PRODUCTS Home > Products > Fitting Tools > Crimping Tool
 
 
fitting tool
ITEM NO: BZ-1632
  •      

    Crimping force 60KN
    Stroke 17mm
    Aplications Copper Stainltss Steel
      Multi-layer compocite Pipe.Pex Pipe
    Crimp/charge 350times(Cu 150mm2)
    Crimpng cycle 3s-6s(depend on the size of cable)
    Working temperature -10℃~40℃
    Battery DC18v 3.0Ah
    Charger AC100~240V,50~60HZ
    Charging time 2hours
    Rated pressure 63Mpa

                 NOTE: In order to meet demand please provide appropriate size and a

                    standard of tube when place order.

    ACCESSORIES  
    Battery 2pcs
    Charger 1pc
    Sealing ring of cylinder 1set
    Sealing ring of safety valve 1set
    Package plastic case
    Crimping dies refer the ACCESSORIES TABLE
  •   Micro computer control system-automatically detect the pressure when it is crimping,with double safety protect.
     
      Pressure released automatically Function-the tool stop forcing the
    pressing and release 90% pressure when the pressure reached maximum.

     
      The tool equipped with a double piston which characterized by a fast approach towards the connecting material and transfer to high
    pressure automatically by slow crimping.
     
      The crimping head can be smoothly turned by 350°around the longitudinal axis in order to gain better access to tight corners and other difficult working areas.
     
      If a deviation from the set operation pressure or low btter charges is identifide,an acoustic signal sounds and a red display flashes. 
      One key control-press the trigger to start working,half loosing the trigger means stop forcing pressure, loosing fully means piston return to the original position.
     
      Li-ion batteries do neither have a memory effect nor self discharge.
    Evev after long periods of non operation the tool is always rady to operate.In addition we see a lower power weight ratio with 50% more capacity and shorter charging cycles compare to NiMH batteries.

     
      A Temperature sensor makes the tool stop working automatically when the tempreture over 60℃ under long time working, the fault signal sounds, it means the tool can’t continue work the tempreture reduced to the normal. 

BACK >>