PRODUCTS Home > Products > Holemaking > Punch Driver
 
 
Battery Powered Punch Driver
ITEM NO: BZ-12
  • Maximum Punch force 120KN
    Maxium Ram Stroke 25mm
    Cuts/charge 180times
    Battery Voltage 18V, 3.0Ah, Li-ion
    Maximum Round Punch Size
    (in 3.5mm mild steel)
    61.5mm dia
    Maximum Rectangular Size
    (in 3.5mm mild steel)
    35.0*65.0mm
    Charging time Approximately 2 hour
    Description Hole Size(Actual)
    Φ(INCH) Φmm
    1/2" Conduit Size Punch & Die 7/8"        .885 22.50
    3/4" Conduit Size Punch & Die -           1.115 28.30
    1" Conduit Size Punch & Die -           1.362 34.60
    1-1/4" Conduit Size Punch & Die -           1.701 43.20
    1-1/2" Conduit Size Punch & Die 1-15/16     1.951 49.60
    2" Conduit Size Punch & Die 2-3/8       2.146 61.50
    7/16"x3/4" Draw Stud 1 pc  
    3/4"x3/4" Draw Srud 1 pc  
    Spacer 1 pc  
    Sealing Kit 1 set  
    Battery 2 pcs  
    Charger 1 pc  
    Sealing ring of cylinder 1 set  
    Sealing ring safety valve 1 set  
  •   Micro computer control system-automatically detect the pressure when it is crimping, with double safety protect. 
      Pressure released automatically Function- the tool stop forcing the pressing and release 90% pressure when the pressure reached maximum.
     
      The tool equipped with a double piston pump which characterized by a fast approach towards the connecting material and transfer to high pressure automatically by slow crimping.
       
     


    If a deviation from the set operation pressure or low bttery charges is identified, an acoustic signal sounds and a red display flashes.
     

     

      One key control- press the trigger to start working, half loosing the trigger means stop forcing pressure, loosing fully means piston return to the original position. 
      Li-ion batteries do neither have a memory effect nor self discharge. Even after long periods of non operation the tool is always ready to operate. In addition we see a lower power weight ratio with 50% more capacity and shorter charging cycles compare to NiMH batteries.

      A Temperature sensor makes the tool stop working automaticaly when the tempreture over 60"c under long time working, the fault signal sounds, it means the tool cant continue work until the tempreture reduced to the normal. 
BACK >>